Blue Powder Coated Steel Post Pallet Stillage with End Frame

Description:

Stackable blue post pallet with a welded grid deck, four stacking cups and one framed end rail for long stock, built from 500 mm to 6000 mm.

Product Detail

Product Tags

A stackable post pallet for sheet, tube and long stock. The deck is a welded grid so water drains straight through and banding passes under the load, while the four corner posts carry formed cups that take the foot of the pallet stacked on top. One end is framed up to a top rail, giving tall or awkward bundles something to register against and keeping a stack square.

Deck and posts

  • Grid deck of formed channel welded to a perimeter frame, not a flat plate
  • Stacking cups at all four posts, so units locate instead of balancing
  • One framed end with a top rail; the opposite end stays fully open for loading
  • Fork entry on two sides through the base runners
  • Blue powder coat over a pretreated surface, or galvanised for outdoor and washdown use

Why only one framed end

Long loads want a single rigid face to push against. With one end framed and the three other sides open, a bundle of tube or a stack of sheet is dropped in from the open side, shoved up to the rail and banded — quicker than threading it into a full cage, and it still stacks four or five high on the floor or in a rack.

Finish and repair

Coating happens after the frame is welded, so cut edges and corners are covered in the same pass. Pretreatment, dry-off, a 280 °C cure and cool-down take around two hours per unit on our own line; plating and galvanising are the two processes we buy in. Posts, cups and rails are separate weldments — a bent post is cut out and replaced rather than scrapping the pallet.

Size and capacity

Footprint and post height are built to your drawing, from 500 mm to 6000 mm in the longest direction. Working load is 300–3000 kg per pallet depending on deck section and post gauge. Where units stack four high, size the bottom pallet for the whole column, not the average unit.

Typical duty

Sheet-metal and profile stock in a fabrication shop, glass and board offcuts, tube bundles on a supplier loop, and any load that has to be lifted by fork truck and stacked without a rack.

Email: ivy@fsyougu.com | WhatsApp: +86 133 6030 6180

Send your message to us:

INQUIRY NOW
INQUIRY NOW