Timber Lined A-Frame Glass Transport Rack Steel Frame

Description:

Welded steel A-frame with removable timber slats on both faces, so sheet glass rests on wood and arrives unmarked.

Product Detail

Product Tags

The steel does the work, the timber touches the glass

On an A-frame glass rack the frame only has to stay rigid. What determines whether the sheet arrives unmarked is the material in contact with it. Here that is timber: slats run across both inclined faces at set intervals, and the sheet edge rests on wood rather than on steel or on rubber pads.

  • Inclined A-frame in welded steel tube, powder coated on our automatic line
  • Timber slats on both faces, removable and replaceable on site
  • Timber bearers along the base, so the bottom edge sits clear of the floor
  • Base rails left open for fork entry from either side
  • Timber over the frame faces wherever the sheet loads, so the contact points are wood

Why timber and not rubber

Rubber pads leave black transfer marks on clear and low iron glass, and the marks show up after tempering. Timber spreads the load along the edge without marking, and a worn slat is a five minute swap rather than a re-pad of the whole frame. On stone and ceramic the same slats keep the polished face off grit that collects on the base.

Where these go

Glass processors moving cut sizes between the cutting bench and the tempering line. Façade and glazing contractors holding sealed units on site. Stone and slab handlers. Anyone moving flat panel where the face finish is the thing being sold.

Dimensions and capacity

Frame sizes anywhere within 500–6000 mm. Load 300–3000 kg. Give us the sheet thickness range and the largest sheet you handle, and we set the slat pitch and the lean angle from that — a rack built for 6 mm cannot be re-used safely for 25 mm laminated without changing the geometry.

Contact

Email: ivy@fsyougu.com | WhatsApp: +86 133 6030 6180

Send your message to us:

INQUIRY NOW
INQUIRY NOW