Galvanized Stacking Cage Container with Half Drop Gate and Mesh Floor

Description:

Galvanised folding wire mesh container with a half-drop front gate, stacking feet and fork-entry base, built in sizes from 500 mm to 6000 mm.

Product Detail

Product Tags

A galvanised folding cage that goes into pallet racking loaded and comes back collapsed. The front face is split into a half-drop gate, so an operator reaches the bottom layer without dragging the whole container out of the bay, and the four corner posts carry stacking feet that seat into the cage below.

How the cage is built

  • Mesh panels welded into a steel tube frame, hinged at the corners on sleeves with drop pins
  • Half-drop gate on the long face, released by two sliding latches and swung down to deck level
  • Mesh floor over a formed base frame, with fork pockets left clear on both sides
  • Four cast stacking feet, one per post, that locate into the post of the unit underneath
  • Galvanised body as standard, or the same frame powder coated when a fleet is colour coded

Working with it on site

  • Folding takes one person and no tools: pins out, panels in, cage flat
  • Folded units nest, so the return leg moves empty air rather than empty steel
  • The load can be counted through the mesh from the aisle instead of opening the gate
  • Gate, pins and feet are separate parts, so one bent panel is a repair rather than a write-off

Built sizes

Length runs from 500 mm to 6000 mm, with width, height, mesh aperture and wire gauge fixed on the drawing. Working load sits in the 300–3000 kg band depending on gauge and base build — tell us the load and the stacking height and the frame follows from there.

Where it earns its keep

Bulk parts moving between production and despatch, returnable packaging on a fixed supplier route, third-party logistics sites sorting mixed cartons and returns, and rental fleets that need containers to fold flat between hires.

Production notes

Tube and sheet are cut on automated lines and welded by robot in our own plant. Galvanising is the one step we buy in from a specialist. Powder coating, where specified, runs on our own line — pretreatment, dry-off, a 280 °C cure and cool-down, roughly two hours per part.

Email: ivy@fsyougu.com | WhatsApp: +86 133 6030 6180

Send your message to us:

INQUIRY NOW
INQUIRY NOW