Blue Perforated Steel Parts Container with Half-Drop Side Gates

A powder-coated steel parts container with perforated side panels and hinged half-drop gates. The perforation is the working detail: it lets a wash or a dip drain straight out, lets air move through a stack of parts that went in warm, and lets an operator see the fill level from the aisle without opening anything. Closed sheet walls would do none of those.

Construction

• Perforated side panels — punched sheet, framed and reinforced with a rib at mid-height. Drainage, airflow and visibility, with the panel stiffness coming from the frame rather than the sheet.
• Twin hinged gates — the long side opens in two independent halves, each latched with a drop handle. The lower half opens alone when parts are picked out from the side, so the upper half keeps containing the load.
• Four stacking posts — posts run past the top rail and locate in corner brackets at the base of the unit above, so a stack is located on four points.
• Solid base frame — a welded base frame under the box, with feet that keep the perforated floor clear of standing water on a wet slab.
• Powder coated — coated on our own line: dust, oil and rust removal, drying, a 280 °C cure, cooling. On a perforated panel the pretreatment is the whole job — coating over an oily punched edge fails first at the hole rims.
• Forklift handling — the base frame is built for entry under the box.

Where it earns its cost

• Machined parts that come off the line oily or wet and have to drain
• Parts that are washed or dipped while still in the container
• Automotive and motorcycle component supply between stations
• Fastener and small hardware bulk storage where the fill level has to be visible
• Returnable loops where a closed box would trap moisture and a mesh cage would let small parts through

How we build it

We are a factory, not a trading company, and we build to your drawing rather than to stock. Send a photo and our design team will work up the drawing; send a drawing and we build exactly that. Tube cutting, plate cutting, robot welding and the powder coating line are in our own plant — including the punching. Electroplating and hot-dip galvanising are the only processes we send out; this unit is powder coated, so it is made entirely in-house from sheet to finished container.

Size range 500–6000 mm  |  Load capacity 300–3000 kg  |  hole diameter, hole pitch, panel height, gate split and colour all to your specification.

Talk to us about your specification

Tell us the part size — that sets the hole diameter and pitch, and it is the one dimension that cannot be changed after the panel is punched. Tell us too whether the box is loaded by hand or tipped, because that decides whether the base needs a liner.

Email: ivy@fsyougu.com  |  WhatsApp: +86 133 6030 6180