Galvanised Folding Wire Mesh Pallet Cage with Half-Drop Front Gate

A folding wire mesh pallet cage in hot-dip galvanised finish, built for loads that have to leave the factory floor and come back. The four sides fold down flat onto the base, so the empty unit takes roughly a fifth of the space of the erected cage on the return leg — which is normally the number that decides whether a returnable loop pays for itself.

Construction

• Welded mesh panels — the open grid holds loose parts and lets a stock check be done from the aisle instead of by opening each unit.
• Half-drop front gate — the lower half of the front panel releases independently, so parts are loaded and picked from the side without lifting anything over a full-height wall. The upper half stays closed and keeps the load contained.
• Solid deck — a flat base plate under the mesh carries small components without them dropping through, and gives a clean surface for sliding cartons in.
• Stacking feet — the base is profiled so one cage locates on the one below. Four-point location, not a flat-on-flat stack.
• Galvanised finish — hot-dip galvanising for wash-down areas, outdoor yards and humid climates. Powder coating available when the unit has to carry a colour or a customer’s branding.
• Casters optional — the same cage is supplied with swivel and fixed casters where it has to be moved by hand rather than by forklift.

Where it earns its cost

• Returnable packaging loops between a supplier and an assembly plant
• Bulk small parts held at the rack face and picked directly out of the cage
• Warehouse overflow where pallets are too open and tote boxes too small
• Outdoor and wash-down storage, where a painted finish does not last
• Export consolidation — the folded cage is the shipping unit and the storage unit at the same time

How we build it

We are a factory, not a trading company, and we build to your drawing rather than to stock. Send a photo and our design team will work up the drawing; send a drawing and we build exactly that. Tube cutting, plate cutting, robot welding and the powder coating line run in our own plant — the coating line takes parts through dust, oil and rust removal, drying, a 280 °C cure and cooling, roughly two hours end to end. Electroplating and hot-dip galvanising are the only two processes we send out, which is why we quote galvanised work on a longer lead time than powder-coated work.

Size range 500–6000 mm  |  Load capacity 300–3000 kg  |  mesh aperture, panel height, gate position, deck type and finish all to specification.

Talk to us about your specification

Tell us what goes in the cage, how it is handled on and off the truck, and what the return leg looks like. Those three answers set the panel height, the mesh aperture and the stacking arrangement.

Email: ivy@fsyougu.com  |  WhatsApp: +86 133 6030 6180